Gas boiler double channel structure combustion

The pressure of the circulating pump is constant, the current increases, and the flow decreases. This is the metamorphic effect of the thermal fluid, the viscosity increases, and it should be replaced or regenerated in time. The gas boiler is equipped with a computerized boiling water boiler controller. All functions are stored in a smart chip, which can realize intelligent, digital, automated and user-friendly boilers. The boiler intelligently controls the water temperature and automatically stops heating when the water temperature is reached. Display the water temperature, you can see the boiler water temperature at a glance. If the newly heated conductive liquid contains water or does not exclude the decomposition gas in the system, the air valve should be opened immediately to exhaust the gas. When the current of the circulating pump is lower than the normal value, it indicates that the efficiency of the circulating pump decreases and the flow rate decreases. This may be due to dirt and blockage of the heating tube, and the stainless steel chain should be cleaned.



　If only the circulation pump of the gas boiler is abnormal, and the current is reduced, the outlet pressure of the pump will return to zero, which indicates that the pump is idling and there is no oil supply, which may be caused by the evaporation of the engine oil. Therefore, first, find the cause of vaporization and take measures. If the filter is clogged and the circulation pump is empty, you should immediately open the bypass to clean the filter; otherwise, close the bypass. If the system does not exclude gas-containing water caused by new thermal fluid. If the water breaks, open the air valve immediately.

　　To deal with this phenomenon, the gas boiler must be manually reversed to remove debris, replace the broken grate and restart. If it gets stuck again after starting, it will check the cause after stopping the rotation, and then solve the problem. At the same time, the adjustment screws on both sides should be readjusted to tighten the furnace. If it is still abnormal, the sprocket needs to be replaced.