What do you think?
Rate this book
Design of a Gang Programmer Using AVR Microcontrollers
The objective of this project was to design a low cost gang programmer which could program multiple serial EEPROMs at a time from a single master EEPROM. A prototype has been developed for the same using the AVR ATmega32 microcontroller which is an 8 bit RISC microcontroller. The EEPROMs to be programmed were 24C16 (16Kb) serial EEPROMs.The capacity of the gang programmer developed far surpasses the capacities of most commercially available EEPROMs and is sure to satisfy the requirements of most industries at less than 10% of the cost normally incurred.
68 pages, Paperback
Published April 19, 2018
Ratings & Reviews
Friends & Following
Create a free account to discover what your friends think of this book!
Community Reviews
No one has reviewed this book yet.